yeshuaskid wrote:I've been told that you can put a nylon around the filter bottom and it keeps the sand out. Has anyone tried that? I'm asking because I'm probably going to have to dump Squirts tank of all its sand since he's in one of those turtle tanks that has one side cut out for a filter. I didn't purchase this tank. It came with the turtle and I'm upgrading as soon as possible. Since I have to put a new filter in today, should I just take the sand out completely?
what you are talking about is also called a prefilter. Here's a little snippet from the sand FAQ about prefilters:
What about a Prefilter on the intake?
You can use those if you like, it's added insurance that sand wont get sucked up into your filter. Remember to take it off and clean it off often otherwise it being dirty will restrict your filters flow. You can get them on the coarse(about 10-20PPI) or fine side(30-40PPI), I would recommend coarse, because it will have less of an impact on the suction power and won't get clogged as fast. Prefilters are readily available for most filters, or you can just buy ones made for the Aquaclear power filters, and make your own.
unless you can make the intake 3-4" above the sand, then i would suggest that you do remove the sand until you have a larger non turtle tank.
