Habitat - Indoor :: Hey grey goose

[Poz]

I have a question for you. How did you make that little ledge on the left side of your tank, that is under water but still the turtle can get its head out of the water?

[adam85491]

Isn't Poz the name of an Easter egg dying kit? Off topic I know but still lol

[Poz]

Lol I have no idea but its a nick name from my last name

[turboturtle8]

I think You are thinking of Paz that is what it is called

[N4784N R4613]

Here is a post about them...
http://www.redearslider.com/forum/viewt ... 7956#67956

[grey goose]

Sorry I seem to have missed this post........Later tonight I'll take some pics of the one on my 55 gal. It's the same size as the 90 gal one, but easier to take a pic of. Stay tuned

[grey goose]

I cut 1" strips and used aquarium silicone to attach them to the tank. Set your lines with a small T-square all around the outside three sides of the tank, using a felt tip marker (remove it with denatured alcohol after you're done) It's important to spread a good layer of silicone onto the strip, then press firmly (this part can get messy, have some paper towels within reach. Try to get rid of as many air bubbles as you can while pressing from the center to the ends, while keeping it lined up with your mark. Set up all three strips, then let it set for 24 hours. Then trim all the excess with a single edge razor. Also leave some space at the corners.



The rest of the thread that N4784N R4613 posted pretty much explains everything else....If you have any Q's feel free to PM me.